跳到正文
返回论文列表
cs.CE提交于 已译

超声速与高超声速流中薄板的结构保持降阶模型

Structure-preserving reduced-order models of thin panels in supersonic and hypersonic flow

Miguel A. Aguilo

中文摘要

面向 AePW-4 High-Speed Working Group 的两个挑战问题,构建结构保持降阶模型:Mach 1.92 下的固支薄板 RC-19,以及 Mach 5.85 下的悬臂板 HyMAX。现有数据既无时间分辨响应,也无重复试验,因此物理规律必须由模型结构承载。Ritz-Galerkin 参考模型用于描述板;学习模型保留其精确势能,仅拟合其余广义力,并训练不会增加能量的耗散项,故任意权重下均满足能量平衡。RC-19 上最差相对残差为 2.2e-15;激波关系预测的跨板压力比为 1.521,与压力敏感漆测量一致。30 次运行所得主频均值与实测 236 Hz 相差不超过 1.0%;在周期和混沌工况的 16 次运行中均复现已发表降阶模型的响应状态,同时消除了测量中不存在的 113 Hz 谱峰。加入一个满足能量平衡的力后,测量位移可校正混沌响应;在实验 5 kHz 采样率下,无噪声状态误差为板厚的 1.25%,10 微米噪声下为 3.5%。HyMAX 上,学习模型以 3.7% 相对误差跟踪参考模型后缘位移 65 ms。

关键要点

  1. 01现有数据缺少时间分辨响应与重复试验,需以模型结构承载物理规律
  2. 02学习模型仅拟合广义力和不可增能的耗散项,任意权重下均满足能量平衡
  3. 03RC-19 压力比预测与实测均为 1.521,主频均值与实测 236 Hz 相差不超过 1.0%
  4. 04测量位移可校正混沌响应,状态误差在无噪声时为板厚的 1.25%
  5. 05HyMAX 后缘位移跟踪持续 65 ms,相对误差为 3.7%

解读

尚无解读。

原始英文摘要

arXiv:2610.31504v1 Announce Type: cross Abstract: We build structure-preserving reduced-order models for both challenge problems of the AePW-4 High-Speed Working Group. They are a clamped thin panel at Mach 1.92 (RC-19) and a cantilever plate at Mach 5.85 (HyMAX). The published data for each case hold no time-resolved response and no repeated runs. The physics must therefore be carried by the form of the model. One construction gives two models per problem. A Ritz-Galerkin reference model describes the plate. A learned model keeps the reference model's exact potential, fits the remaining generalized forces, and trains only a dissipation that cannot add energy. Its energy balance holds for any weights by construction. On the trained model the worst relative residual is 2.2e-15. On RC-19, shock relations predict a pressure ratio of 1.521 across the panel. Pressure-sensitive paint measured the same value. Thirty runs of the learned model place the mean dominant frequency within 1.0% of the measured 236 Hz. At one periodic and one chaotic condition, the learned model reproduces the response regime of a published reduced-order model in all sixteen runs. It does so without that model's 113 Hz spectral peak, which the measurements do not show. Measured displacements can also correct the chaotic response through one more force that respects the energy balance. We tested this on synthetic data at the experiment's 5 kHz sampling rate. The state error is 1.25% of the panel thickness without noise and 3.5% with 10 micrometers of noise. On HyMAX the learned model follows the reference model's trailing-edge displacement for 65 ms with a relative error of 3.7%. These results show that a model whose structure carries the physics can match measured flutter behavior when the available data cannot train it.

同方向论文 · cs.CE

查看全部 →